J2 Retail Systems J2 650 Specifications download pdf (Page 72)

650 System Manual (Draft)

Version 0.4 August 20, 2008

650 UPS

Specifications

Hardware

To install and use the J2 UPS module:

1: Remove the power supply adapter form the base of the unit.

2: Install the UPS module where the power supply was mounted.

3: Connect the power output jack of the UPS to the power in jack of the unit.

4: Connect the Serial cable of the UPS to the serial port you wish to use. *

5: Connect the power supply adapter to the UPS power in jack.

6: Connect the power supply adapter to the mains power. **

7: Configure the Windows UPS drive as shown.

Picture to be added here

* The serial port connection is not needed for Windows CE.

** The mains power should be applied for 3 hours to fully charge the batteries. The unit

may be running during this time but will take longer to charge.

Batteries Run Time 2 Hours for the standard 650. Run time will vary

depending on the processor used and application load

Power In 19 Volts DC

Power Out 13-16.8 Volts DC, 7.2 amps maximum

Data Interface RS232 DB9 connector

Batteries Type 2 – 4 18650 cell Li-Ion pack with protection circuit

Battery Life 300 full discharge cycles

Charge Time 3 hours

Charger Type Smart Microcontroller based

Software XP Standard Generic UPS driver / J2 Smart UPS driver

Size 6” x 3.1” x 1.7” (152mm x 79mm x 43mm)

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 78

No comments

J2 Retail Systems J2 650 Specifications Page 72